USB/Party Buffalo issue

  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #390378
    Cmdr Xym
    Participant

      Please be kind to the non tech-savvy customs newbie here… <img decoding=” src=”/wp-content/uploads/invision_emoticons/default_SA_biggrin.gif” />

       

      Started playing with customs a few weeks ago. A bit shaky at the start, but eventually got everything up and running just fine. Had 200+ songs to start with, on an 8GB flash drive. Used Party Buffalo to install songs. Using TU4 on that drive.

       

      So once I got around 240 songs, I found that I couldn’t load more songs. PB would inject them, but when I went back to view them, it was like nothing had happened. I noticed I had nearly maxed out the flash drive, so I deleted a couple of songs to make room and troubleshoot. Again, couldn’t add songs.

       

      Today, bought a 128GB drive. Installed everything like brand new without a hitch. Tested it out, songs played fine, but about a dozen were missing. Tried reloading those songs. Again, PB acts like it injects the songs, but it really doesn’t. Now I’m stuck. Can’t add more songs.

       

      I’ve searched through all the forums and tried a few things, but nothing seems to work. :confused:

       

      Could really use some help here figuring this out. Thanks!

      #419915
      Spindoctor
      Participant
        Please be kind to the non tech-savvy customs newbie here… <img decoding=” src=”/wp-content/uploads/invision_emoticons/default_SA_biggrin.gif” />

         

        Started playing with customs a few weeks ago. A bit shaky at the start, but eventually got everything up and running just fine. Had 200+ songs to start with, on an 8GB flash drive. Used Party Buffalo to install songs. Using TU4 on that drive.

         

        So once I got around 240 songs, I found that I couldn’t load more songs. PB would inject them, but when I went back to view them, it was like nothing had happened. I noticed I had nearly maxed out the flash drive, so I deleted a couple of songs to make room and troubleshoot. Again, couldn’t add songs.

         

        Today, bought a 128GB drive. Installed everything like brand new without a hitch. Tested it out, songs played fine, but about a dozen were missing. Tried reloading those songs. Again, PB acts like it injects the songs, but it really doesn’t. Now I’m stuck. Can’t add more songs.

         

        I’ve searched through all the forums and tried a few things, but nothing seems to work. :confused:

         

        Could really use some help here figuring this out. Thanks!

         

        Xbox will only recognize up to 32 gigs on any combination of usb drives, two 16s etc. You might be more than 32 gigs.

        If you don’t play on line any more, it’s easier to just install the songs to the xbox hard drive or look at garage sales for old cheap xbox 360’s and use for customs only. Also I have never had good luck with Partybuffalo. I downloaded Horizon & haven’t had a problem since.

        #419935
        espher
        Participant

          If you’ve got two sticks, load them on the smaller stick on your PC, then connect both to the Xbox and transfer them to the larger stick there.

           

          Or use Horizon or another program for the transfer to get you over the ‘hump’ — PB should be fine again after that.

          #419940
          Cmdr Xym
          Participant

            After much trial and error (and going to bed very late), I ended up using Horizon and apparently got everything to show in RB3.

          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.
          Back to top button